One drawback is that the feet are not adjustable so I used thin rubber washers to make any adjustments. First thing I did was ensure the table and unit were perfectly level in three directions. I was prepared to spend an hour or so on the setup. I will say that the setup is not for the feint of heart. So my first piece of advice is Google this brand and model and read some different reviews, and also watch Youtube videos.Īfter being confident about what to expect from this purchase, I pulled the trigger. I wanted to be sure I knew what I was getting into. I had not found any other turntable with this level of features at this price point, and that was definitely a concern. I did quite a bit of reading and research prior to settling on purchasing the Angels Horn turn table. I am a total newb to the world of vinyl but I had been wanting to get into vinyl for a while. If you are unfamiliar or uncomfortable with completing this procedure, we recommend consulting with a professional to perform the installation. Tighten the screws completely once the perfect alignment is achieved. Fine tune the cartridge’s position on the headshell until the cartridge is perfectly in parallel with the reference lines at both points.ħ. To achieve this, place the included paper cartridge alignment protractor over theturntable spindle, carefully lift the tone arm and place the tip of the stylus on the points marked 130mm and 250mm respectively. Adjust the cartridge’s position to make sure it is precisely aligned on the headshell so that the stylus will be tracking the grooves in parallel perfectly. White Left channel positive (L+) Red Right channel positive (R+)īlack Left channel negative (L–) Black Right channel negative (R-)Ħ. Connect the wire leads to the new cartridge’s terminals. Do not completely tighten the screws at this moment.ĥ. Mount the new cartridge to the headshell and tighten it lightly. Loosen the two screws on the headshell that are securing the cartridge and then remove the original cartridge.Ĥ. Carefully remove the wire leads from the original cartridge.ģ. Before replacement, put the stylus protector back on the stylus to prevent damage to the stylus during the replacement process.Ģ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |